IEC 61169-16:2006

IEC 61169-16:2006 defines the sectional specification for radio-frequency connectors with an inner diameter of outer conductor of 7 mm and screw coupling, covering type N connectors with 50 ohms and 75 ohms characteristic impedance. For engineering teams, laboratories, and procurement specialists, IEC 61169-16:2006 serves as a focused technical reference for product selection, documented evaluation, and conformity assessment. It helps align connector requirements with testing workflows, mechanical compatibility checks, and compliance preparation where RF performance and consistent interface definition matter.

What is IEC 61169-16:2006?

This document provides the sectional specification for a family of RF coaxial connectors identified as type N, using a 7 mm outer conductor inner diameter and screw coupling. Its purpose is to define the technical basis used in design review, product evaluation, and verification activities for connectors in this interface class. IEC 61169-16:2006 is typically consulted when organizations need a compliance reference for procurement, laboratory evaluation, or engineering documentation tied to RF connector characteristics and interchangeability expectations.

Applications of IEC 61169-16:2006

IEC 61169-16:2006 is relevant in workflows involving RF equipment, test setups, communication systems, and other electrical equipment that uses type N coaxial interfaces. It is commonly used during specification review, connector selection, incoming inspection, and technical validation of assemblies or components. Laboratories and manufacturers may rely on it when comparing product suitability, checking interface consistency, or preparing documentation for quality workflows and regulatory preparation connected to RF hardware.

Why is IEC 61169-16:2006 important?

This technical document matters because connector interfaces are often a source of fit, performance, and interoperability issues if they are not defined consistently. IEC 61169-16:2006 supports risk reduction by giving teams a clear basis for conformity assessment, testing consistency, and engineering validation. It can help procurement and compliance groups verify that a connector family matches the required interface class before purchase, installation, or formal acceptance. In practice, it supports operational consistency across technical review and quality assurance processes.

• Sectional specification for type N RF coaxial connectors with screw coupling
• Covers 7 mm inner diameter of outer conductor interface definitions
• Addresses 50 ohms and 75 ohms characteristic impedance variants
• Useful for product evaluation, procurement review, and laboratory verification
• Supports conformity assessment and engineering documentation for RF connector workflows