IEC 61169-64:2019

IEC 61169-64:2019 defines the sectional specification for RF coaxial connectors with a 0,8 mm inner diameter of outer conductor and a characteristic impedance of 50 Ω, identified as type 0,8. For engineering teams, laboratories, and procurement specialists, it serves as a focused technical reference for assessing connector form factor, interface expectations, and suitability within high-frequency assemblies. IEC 61169-64:2019 is most relevant where documented evaluation, technical validation, and conformity assessment depend on a clear connector specification rather than a general product description.

What is IEC 61169-64:2019?

This document is part of the IEC 61169 series and provides a sectional specification for a specific RF coaxial connector type. Its purpose is to support technical review by defining the connector family in a way that can be used for design selection, verification activities, and compliance workflows. Because it addresses connectors with a 0,8 mm inner diameter of outer conductor and 50 Ω impedance, it is typically used when teams need a precise engineering specification for RF connection interfaces and related documentation control.

Applications of IEC 61169-64:2019

IEC 61169-64:2019 is relevant in RF hardware development, connector procurement, and laboratory evaluation where compact coaxial interfaces must be identified and controlled consistently. It may be used during product evaluation for equipment that depends on stable signal interconnects, as well as in test setups where connector compatibility affects measurement repeatability. The reference is also useful in engineering documentation for assemblies, qualification plans, and quality workflows that require a clear technical baseline for 50 Ω RF connector selection.

Why is IEC 61169-64:2019 important?

Using IEC 61169-64:2019 helps reduce ambiguity in technical assessment and supports consistent interpretation of a specialized connector interface. That matters for interoperability, procurement review, and conformity assessment preparation, especially when multiple suppliers or test environments are involved. A well-defined sectional specification can improve testing consistency, support risk management, and strengthen engineering validation by giving teams a shared compliance reference for the connector type and impedance category under review.

• Sectional specification for RF coaxial connectors of type 0,8 with 50 Ω characteristic impedance
• Useful for design review, connector selection, and engineering documentation control
• Supports laboratory evaluation, verification activities, and repeatable test planning
• Helps procurement and compliance teams compare products against a defined technical reference
• Relevant to conformity assessment and technical validation workflows for RF assemblies