IEEE 1301.1-1991

1301.1-1991 is a technical standard for cooled components using 2 mm connectors, with a focus on computing and processing equipment, circuits, devices, and related systems. It is relevant where connector geometry, cooling arrangement, and reliable electrical interfacing must work together in a defined engineering context. By setting a clear reference point for this type of hardware, 1301.1-1991 helps support consistent design choices, comparison, and procurement of compatible parts or assemblies.

About 1301.1-1991

This standard appears to address a specific cooled connector-based component arrangement rather than a broad computer-system requirement. The subtitle, “Cooled With 2 Mm Connectors,” suggests attention to physical interface details, likely within assemblies where heat management and stable connection performance are important. In practice, 1301.1-1991 would be used as a technical reference for evaluating form factor, connector suitability, and related engineering requirements in processing hardware or electronic subsystems.

Where is 1301.1-1991 used?

1301.1-1991 is most relevant in electronics and computing applications where compact connector interfaces and cooling provisions must be coordinated. That may include processing modules, circuit assemblies, device interconnects, or systems that depend on controlled thermal behavior and dependable 2 mm connector alignment. It can be useful in design review, parts selection, maintenance documentation, and compatibility checks for hardware built around tightly specified electrical and mechanical interfaces.

Importance in practice

Using 1301.1-1991 as a reference helps reduce ambiguity when specifying or reviewing cooled hardware with 2 mm connectors. Clear requirements can improve consistency across design, testing, and procurement, especially when connector fit, thermal considerations, and electrical reliability all affect performance. For teams working with legacy or inactive standards, it also provides a stable document basis for tracing earlier design decisions, comparing assemblies, or maintaining older equipment to a known technical baseline.

• Cooled hardware interface
• 2 mm connector alignment
• Computing and processing applications
• Design and procurement reference