SAE AS3132A

UPDATED SUPPLIER PART NUMBERS, CLARIFIED PART MARKING, CORRECTED DIMENSIONAL ERRORS, UPDATE MATERIAL USAGE AND GENERAL SAE UPDATING FOR OBSOLETE SPECIFICATIONS AND FORMATING REQUIREMENTS. 1 MATERIAL: 303 CRES BAR PER AMS5640, TYPE 1 (UNS S303000). 2 HEAT TREAT: PER AMS5640. 3 CLEANING: FINISHED PARTS SHALL BE DEGREASED AND IMMERSED FOR 30 MINUTES IN A SOLUTION CONTAINING 40% BY VOLUME OF NITRIC ACID (SPECIFIC GRAVITY 1.42) AND 2.5% BY WEIGHT OF SODIUM DICHROMATE AT ROOM TEMPERATURE. 4 PINS ARE PREWAXED TO AID DRIVING. 5 SURFACE TEXTURE: SYMBOLS PER ASME Y14.36M, REQUIREMENTS PER ASME B46.1. UNLESS OTHERWISE SPECIFIED, SURFACES TO BE 250 MICROINCHES Ra. 6 BREAK EDGES .003 TO .015 UNLESS OTHERWISE SPECIFIED. 7 DIMENSIONS IN INCHES. UNLESS OTHERWISE SPECIFIED, TOLERANCES: ANGULAR DIMENSIONS ±2 degrees. DIMENSIONS APPLY AFTER FINISH. /8/ MARK AS3132-( ) PART NUMBER AND MANUFACTURER’S PART NUMBER ON PACKAGE IN ACCORDANCE WITH AS478, METHOD 37. 9 USE WITH AS3131 PLUGS. SEE AIR3277 INSTALLATION PROCEDURES. 10 DIMENSIONING AND TOLERANCING: ASME Y14.5M-1994. 11 DO NOT USE UNASSIGNED PART NUMBERS. 12 SEE AS3587 FOR PLUG AND PIN SET OF PARTS. 13 AS, AIR AND AMS ARE SAE INTERNATIONAL PUBLICATIONS. ASME IS AN AMERICAN SOCIETY OF MECHANICAL ENGINEERS PUBLICATION. 14 A CHANGE BAR ( | ) LOCATED IN THE LEFT MARGIN IS FOR THE CONVENIENCE OF THE USER IN LOCATING AREAS WHERE TECHNICAL REVISIONS, NOT EDITORIAL CHANGES, HAVE BEEN MADE TO THE PREVIOUS ISSUE OF THIS DOCUMENT. AN (R) SYMBOL TO THE LEFT OF THE DOCUMENT TITLE INDICATES A COMPLETE REVISION OF THE DOCUMENT, INCLUDING TECHNICAL REVISIONS. CHANGE BARS AND (R) ARE NOT USED IN ORIGINAL PUBLICATIONS, NOR IN DOCUMENTS THAT CONTAIN EDITORIAL CHANGES ONLY. APPROVED SOURCE OF SUPPLY: THE LEE CO WESTBROOK, CT FEDERAL SUPPLY CODE FOR MANUFACTURER’S NO 92555. ONLY THE ITEM DESCRIBED ON THIS DRAWING WHEN PROCURED FROM THE VENDOR LISTED HEREON IS APPROVED FOR USE IN THE APPLICATIONS SPECIFYING THIS AEROSPACE STANDARD IDENTIFICATION NUMBER. A SUBSTITUTE ITEM SHALL NOT BE USED WITHOUT PRIOR TESTING AND APPROVAL BY THE DESIGN ACTIVITY RESPONSIBLE FOR THE APPLICATION. IDENTIFICATION OF THE APPROVED SOURCE HEREON IS NOT TO BE CONSTRUED AS A GUARANTEE OF PRESENT OR CONTINUED AVAILABILITY AS A SOURCE OF SUPPLY FOR THE ITEM DESCRIBED ON THE DRAWING.