SAE J2894/1_201901

The intent of this document is to develop a recommended practice for PEV chargers, whether on-board or off-board the vehicle, that will enable equipment manufacturers, vehicle manufacturers, electric utilities, and others to make reasonable design decisions regarding power quality. The three main purposes are as follows: 1 To identify those parameters of PEV battery charger that must be controlled in order to preserve the quality of the AC service. 2 To identify those characteristics of the AC service that may significantly impact the performance of the charger. 3 To identify values for power quality, susceptibility, and power control parameters which are based on current U.S. and international standards. These values should be technically feasible and cost effective to implement into PEV battery chargers. SAE J2894/2 will describe the test methods for the parameters/requirements in this document. This document has a high potential to be used by regulatory state agencies to become a basis for a regulation. Therefore, the document has been reviewed to have accurate power quality definitions and requirements. Some of the requirements were too strict for vehicle onboard charger design point of view. After discussions among vehicle OEMs and utilities, the requirements have been updated.